How Should The Blades Of Electric Hedge Trimmers Be Adjusted And Replaced?

When using a hedge trimmer, it is found that the pruning effect is not as good as before, so it is necessary to adjust the blades of electric hedge trimmers, how do adjust? The following hedge trimmer technicians will introduce you to the adjustment method:

Electric hedge trimmers are fixed by nuts and screws. When fixing, pay attention to loosening the nut first, and then turn the bolt clockwise until it stops. Note that the screw needs to be screwed up for half a turn. To ensure fastening, a screwdriver must be used. After the blade has been adjusted by the bolt and nut, it needs to be smoothed again with lubricating oil.

If you find that the blade is dull and electric hedge trimmers do not run smoothly, the blade needs to be ground. When grinding, you should avoid grinding the surface of the blade or the joint.

When sharpening electric hedge trimmers, hold the grinder at a 45-degree angle and use the sanding edge to sharpen the blade.

When replacing the hedge trimmer blade, you need to turn off the power to avoid injury caused by the automatic start of the machine. In addition, you need to wear gloves when replacing the blade and take protective measures. The specific method is:

Remove the old blade, fix the cutter by hand, loosen the blade nut, and take out the bolt and the blade. When the old blade is taken off, all the bolts and nuts will be taken off at the same time. Install the prepared new blade and tighten the nut. If there are weeds on the blade, keep it clean.

Regarding the precautions for replacing the hedge trimmer blade, if you do not know the model and size of the replacement blade, you can consult the purchaser. The above is the adjustment method of the electric hedge trimmers blade. When using the blade in daily life, the sharpness and fastness of the blade must be ensured.